6.1 Camera
If the NVR doesn't detect any IP cameras, the Basic, PTZ, Tracking, Pattern Tour and Adjust
setting pages cannot be used. Therefore, make sure the IP cameras are properly connected to
the NVR via the Smart Switch.
6.1.1
Camera Status
This page displays connected IP cameras' status and also allows users to modify the ID and
Password of the IP cameras.
Channel: Displays the channel number.
Name: Shows the name of the connected IP camera.
Frame Rate: Shows the current frame rate of the connected IP camera.
Bit Rate: Shows the current Bit Rate of the connected IP camera.
PoE Power: Shows the current Bit Rate of the connected IP camera.
Status: Shows the connection status.
Record: Shows the recording status.
Modify: Click to bring up the following window and you can modify the ID and Password of
the connected IP camera.
Figure 6-3
Figure 6-2
55
ENVR8304D-8CH