Table of Contents
Advertisement
ENVR8304D-8CH
6.8 System Setting
You can configure the general settings for the NVR in this menu.
6.8.1 Date/Time
You can set up the date and time for the NVR.
Figure 6-46
Date: Click to bring up the on-screen keyboard to set up the date.
Time: Click to bring up the on-screen clock to set up the time.
Date Format: Select a date format from the drop-down list.
Time Format: Select a time format from the drop-down list.
Time Zone: Select a time zone for the NVR to adjust to when updating from the time server.
NTP: Select Disable / Enable for NTP time synchronization.
NTP Server: Displays the time server address that the NVR uses for time synchronization.
Requires operating network configuration and WAN or LAN access to a compatible NTP
server. To find a compatible NTP address, follow the steps below:
a. Use a computer connected to the Network.
b. Click Start > Run > type "command" and then click OK.
c. In the DOS Prompt, type "ping pool.ntp.org" to find out the IP address of an NTP Server.
NTP Update Interval: The frequency that the system automatically updates the time via the
NTP server. Select Daily, Weekly or Monthly.
104
Advertisement
Table of Contents
