Table of Contents
Advertisement
Connection Procedure:
The First step is to purchase or make a straight through cable. We recommend
purchasing one if you have never made a straight through cable. Please remember
you can not use a cross-over network cable for this application.
Once you have a straight through cable, plug one end into the LAN port on the back
of the recorder and the other into the router.
Log into the EverFocus NVR menu and go to the Network Setting Menu.
To let the router automatically assign an address:
Set the Network Type to DHCP. Make sure to write down the IP address and the
Gateway.
Exit from the Menu to save settings.
To manually assign an address:
Go to a computer connected on the same network as the NVR.
Click on the Start button and choose Run.
If using Windows Vista, choose Search instead.
Type "command" and click on OK.
In Vista, you will need to double-click on the "Command Prompt" file to open it.
In the DOS prompt, type "ipconfig" and press Enter.
The network information will be displayed on a screen similar to the one below.
In Windows Vista, look for the information that says "IP v4".
Figure 2-17
19
ENVR8304D-8CH
Advertisement
Table of Contents
