Table of Contents
Advertisement
ENVR8304D-8CH
6.3.3
Motion
Figure 6-17
Camera: Select a camera to be configured.
Enable: Check the box to enable the Motion Event settings for the selected camera.
Log: Check the box to record motion events to log data.
Pre-alarm Record: Check the box to start copying the recordings to the hard disk from 5
seconds before the motion event occurs. Note that the pre-alarm recording rate will follow
the Normal Speed configured in the above section (see 6.1.2 Basic).
Buzzer: Check the box to enable the buzzer when a motion event is triggered.
Email Notify: Check the box to send email notification when a motion event is detected.
Email operation requires valid email entered in the Email setup menu (see 6.6.2 Email).
Network Alarm: Check the box to send out a network alarm to a client PC when motion
occurs. This feature works with EverFocus' CMS software. You will need to configure the
Alarm Server for the NVR to send network alarms to the client PC (see 6.6.5 Alarm Server).
Auto Lock: Check the box and the events will be recorded in a write protected segment of
the hard disk (will not be overwritten). The NVR will lock a period of time when the alarm
occurs. The length of the time depends on NVR setting (see 6.4.2 Lock / Format).
73
Advertisement
Table of Contents
