Table of Contents
Advertisement
7. To jump to a Preset Position:
a. Click the Preset button.
b. Click the desired Preset number.
c. Click the Go button.
8. Shortcut for Preset 1 ~ 9:
a. Click digit 1 ~ 9 button without clicking any other buttons.
b. The camera will seek that Preset Position.
9. To delete a Preset Position (if supported by the camera):
a. Click the Preset button.
b. Click the desired Preset number.
c. Click the Delete button.
10. To operate the Auto Pan function, click the Auto Pan button.
11. To operate the Pattern function, click the Pattern button. The Pattern is the "0" Tour in
EverFocus and Pelco PTZ cameras.
12. To operate the Tour function:
a. Click the Tour button.
b. Click the desired Tour number.
c. Click the Go button.
13. To remove a pre-configured Tour (if supported by the camera):
a. Click the Tour button.
b. Click the desired Tour number.
c. Click the Delete button.
Click C to clear the entered number in the Number Box.
Note: Before start using the Auto Pan, Pattern and Tour functions, you have to configure the
related settings for the connected PTZ cameras. Please refer to 7.5.2.2 PTZ or the User's
Manual of your PTZ cameras.
Control PTZ Camera over EKB200 Keyboard:
When using an EKB200 keyboard, you need to click the Connect button on the PTZ Control
Panel. Please note that you need to configure the PTZ control functions and define the function
for each control key on the keyboard before controlling the PTZ camera over the EKB200
keyboard (see 7.5.2.2 PTZ and 6.8.6 EKB200). For information about the installation of the
EKB200 keyboard, please refer to your EKB200 keyboard User's Manual.
142
ENVR8304D-8CH
Advertisement
Table of Contents
