Table of Contents
Advertisement
1.
Select a camera first and double-click on desired start time block (no number on it) on
a time bar. The selected time block will show a new sequence number on it and all the
following blocks will turn to gray. This means the grey time blocks has been set to No
Recording mode.
2.
To change the time blocks to different record mode (which shows a different color),
users need to double-click again on the block (with number on it) of any section. Every
time the user clicks the first block of a section, the color switches from gray->pink
->blue-green.
3.
Repeat the above steps to configure the record modes. You can configure up to six
record modes on each time bar.
Click the "Edit Timezone" button to edit the recording parameters for a time zone.
Editing Timezone:
From: Displays time zone start time.
To: Displays time zone end time.
Record: Displays Record mode.
Resolution: Recording resolution is displayed.
Action: Check this box to enable notifications enabled elsewhere (Buzzer, Alarm out, E-mail,
and Network Alarm) when an event occurs.
Figure 6-43
102
ENVR8304D-8CH
Advertisement
Table of Contents
