Table of Contents
Advertisement
ENVR8304D-8CH
6.3 Event
You can configure the Alarm, Connection Loss, Motion and Other settings in this menu.
6.3.1
Alarm
Figure 6-15
Alarm: Select an Alarm input number from 1 to 2.
Enable: Check the box to enable the Alarm trigger function for the selected alarm input.
Log: Check the box to record alarm events to log data.
Pre-alarm Record: Check the box to start copying the recordings to the hard disk from 5
seconds before the alarm event occurs. Note that the pre-alarm recording rate will follow the
Normal Speed configured in the earlier section (see 6.1.2 Basic).
Buzzer: Check the box to enable the buzzer when an alarm event is triggered.
Email Notify: Check the box to send email notification when an alarm event is detected.
Email operation requires valid email entered in the Email setup menu (see 6.6.2 Email).
Network Alarm: Check the box to send out a network alarm to a client PC when an alarm
event occurs. This feature works with EverFocus' CMS software. You will need to configure
the Alarm Server for the NVR to send network alarms to the client PC (see 6.6.5 Alarm
Server).
69
Advertisement
Table of Contents
