Led Indications - Planet MGSD-10080F User Manual

■ Digital Input
The digitail input of the Managed Switch can be activated by the external sensor that senses physical changes. These
changes can include intrusion detection or certain physical change in the monitored area. For examples, the external
sensor can be a door switch or an infrared motion detector.
■ Digital Output
The digital output main function is to allow the Managed Switch to trigger external devices, either automatically or by
remote control from a human operator or a software application.

2.1.2 LED Indications

 System
LED Color
PWR Green
DC1 Green
DC2 Green
Fault Green
Ring Green
R.O. Green
 Per SFP Interface
LED Color
1000
Green
LNK/ACT
100
Orange
LNK/ACT
 Per 10/100/1000Base-T Interface
Lights to indicate that the Switch is powered on by AC input.
Lights to indicate that the Switch is powered on by DC1 input.
Lights to indicate that the Switch is powered on by DC2 input.
Lights to indicate that Switch AC/DC or port has failed.
Lights to indicate that
the ERPS Ring has been created successfully.
Lights to indicate that
Switch has been enabled Ring Owner.
Lights: To indicate the link through that port is successfully established with speed
1000Mbps.
Blink: To indicate that the switch is actively sending or receiving data over that port.
Off: If L100 NK/ACT LED light-> indicate that the port is operating at 100Mbps.
If LNK/ACT LED Off -> indicate that the port is link down.
Lights: To indicate the link through that port is successfully established with speed
100Mbps.
Blink: To indicate that the switch is actively sending or receiving data over that port.
Off: If 1000 LNK/ACT LED light-> indicate that the port is operating at 1000Mbps
If 1000 LNK/ACT LED Off -> indicate that the port is link down.
User's Manual of MGSD-10080F
Function
Function
37