Qos Qcl Add - Planet MGSD-10080F User Manual

Syntax:
QoS Storm Broadcast [enable|disable] [<packet_rate>]
Parameters:
enable : Enable broadcast storm control
disable : Disable broadcast storm control
<packet_rate>: Rate in fps (1, 2, 4, ..., 512, 1k, 2k, 4k, ..., 1024k)
Default Setting:
disable

QoS QCL Add

Description:
Add or modify QoS Control Entry (QCE).
If the QCE ID parameter <qce_id> is specified and an entry with this QCE ID already exists, the QCE will be modified.
Otherwise, a new QCE will be added. If the QCE ID is not specified, the next available QCE ID will be used. If the next
QCE ID parameter <qce_id_next> is specified, the QCE will be placed before this QCE in the list. If the next QCE ID is not
specified and if it is a new entry added, the QCE will be placed last in the list. Otherwise if the next QCE ID is not specified
and if existing QCE is modified, QCE will be in the same location in the list. To modify and move the entry to last in the list,
use the word 'last' for <qce_id_next>.
Syntax:
QoS QCL Add [<qce_id>] [<qce_id_next>] [<port_list>] [<tag>] [<vid>] [<pcp>] [<dei>] [<smac>] [<dmac_type>] [(etype
[<etype>]) | (LLC [<DSAP>] [<SSAP>] [<control>]) | (SNAP [<PID>]) | (ipv4 [<protocol>] [<sip>] [<dscp>] [<fragment>]
[<sport>] [<dport>]) | (ipv6 [<protocol>] [<sip_v6>] [<dscp>] [<sport>] [<dport>])] [<class>] [<dp>] [<classified_dscp>]
Parameters:
<qce_id> : QCE ID (1-256), default: Next available ID
<qce_id_next>
<port_list> : Port List: "port <port_list> or 'all'", default: All ports
<tag> : Frame tag: untag|tag|any
<vid> : VID: 1-4095 or 'any', either a specific VID or range of VIDs
<pcp>
<dei> : Drop Eligible Indicator: 0-1 or 'any'
<smac>
<dmac_type>
etype : Ethernet Type keyword
: Next QCE ID: "next_id (1-256) or 'last'"
: Priority Code Point: specific(0, 1, 2, 3, 4, 5, 6, 7) or
range(0-1, 2-3, 4-5, 6-7, 0-3, 4-7) or 'any'
: Source MAC address: (xx-xx-xx) or 'any', 24 MS bits (OUI)
: Destination MAC type: unicast|multicast|broadcast|any
546
User's Manual of MGSD-10080F