Table of Contents
Advertisement
> 5 sec: Factory Default
2.1.2 LED Indications
The front panel LEDs indicates instant status of port links, data activity and system power; helps monitor and troubleshoot when
needed.
Figure 2-2
shows the LED indications of these Managed Switches.
LED Indication
■ System
LED
Color
PWR
Green
■ 10/100/1000Base-T interfaces
LED
Color
LNK/ACT
Green
1000
Orange
■ 100 / 1000Base-X SFP interfaces
LED
Color
LNK/ACT
Green
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as below:
。
。
。
。
。
Figure 2-2 GSD-1020S LED panel
Lights to indicate that the Switch has power.
Lights:
To indicate the link through that port is successfully established.
Blink:
To indicate that the switch is actively sending or receiving data over that port.
Lights:
To indicate that the port is operating at 1000Mbps.
Off:
If LNK/ACT LED light-> indicate that the port is operating at 10/100Mbps
If LNK/ACT LED Off -> indicate that the port is link down
Lights:
To indicate the link through that port is successfully established.
Blink:
To indicate that the switch is actively sending or receiving data over that port.
Default Username: admin
Default Password: admin
Default IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Default Gateway: 192.168.0.254
Function
Function
Function
19
User's Manual of GSD-1020S
Advertisement
Table of Contents
