Mep Test Signal Configuration - Planet MGSD-10080F User Manual

'us|ns' calculation results are shown in micro or nano seconds
'keep|reset' the action in case of total delay counter overflow - either 'keep' all results or 'reset' all results
'd2ford1' this is selecting to used two-way DMM for calculate one-way delay.
Syntax:
MEP dm config [<inst>] [<prio>] [uni|multi] [<mep>] [oneway|twoway] [std|prop] [rdtrp|flow] [<gap>] [<count>] [us|ns]
[keep|reset] [d2ford1] [enable|disable]
Parameters:
<inst> : Instance number
<prio> : OAM PDU priority
uni|multi : Destination address is unicast or multicast
<mep> : This MEP id (0-0x1FFF)
oneway|twoway : DM is one-way or two-way
std|prop : Standard or Vitesse proprietary way(w/ follow-up packets) to send DM
rdtrp|flow : 2/4 timestamps selection
<gap> : Gap between 1DM/DMM to send in 10ms(10-65535).
<count> : The number of last records to calculate(10 - 2000)
us|ns : Time resolution
keep|reset : The action to counter when overflow happens
d2ford1 : Enable to use DMM/DMR packets to calculate one-way DM
enable|disable: enable/disable

MEP Test Signal Configuration

Description:
MEP Test Signal configuration
'set|clear' is set or clear of DEI of transmitted LBM frame
'prio' is the priority (PCP) of transmitted TST frame
'mep' is the peer MEP-ID of target MEP - only used if 'mac_addr is 'all zero'
'no_seq|seq' is without and with transmitted sequence numbers
'rate' is the TST frame transmission bit rate in Mbps'
'size' is the size of the un-tagged TST frame - four bytes will be added for each tag
'allzero|allone|onezero' is pattern contained in the TST frame data TLV.
Syntax:
MEP tst config [<inst>] [set|clear] [<prio>] [<mep>] [no_seq|seq] [<rate>] [<size>] [allzero|allone|onezero] [enable|disable]
Parameters:
525
User's Manual of MGSD-10080F