Table 5-7: Iti Automation Format Options - Honeywell ADEMCO MX8000 Installation And Operation Manual

MX8000 Installation and Operation Guide
Option Choices
Log Recs Y (Yes)
N (No)
XID Y (Yes)
N (No)
SupCh
No Data
Note: ITI automation formats are covered in greater detail in Sections 8.8 and 8.10.
Log Recs (For ITI Formats):
1. At the flashing Log Recs field press the
setting.
ENTER
2. Press .
MENU
3. If you wish to exit, press
XID (Extended ID for ITI Panels):
1. At the flashing XID field press the
ENTER
2. Press .
MENU
3. If you wish to exit, press
SupCh (Supervisory Character):
1. At the flashing SupCh [s] field press the
setting.
ENTER
2. Press .
MENU
3. If you wish to exit, press
NoData (No Data Character for Log Record):
1. At the flashing NoData[0] field enter a digit from 0-9 from the touchpad or press the
or button until the display flashes on the desired setting.
ENTER
2. Press .
MENU
3. If you wish to exit, press
5.4.3.6 How to Configure the On-board Annunciator Outputs
Program what will give a trouble annunciation or what will not annunciate from the on-board annunciator.
1. Enter program mode. (See Section 5.1.)
1
2. Press for general options.
3
3. Press for communications.
5–20
Table 5–7: ITI Automation Format Options
Default
N Log records identify the time and date of an incoming
report.
N Extended panel Identification code.
s Supervisory Character is sent from the automation
computer. The receiver will respond with an OKAY or
supervisory record. See Sections 8.9.5 and 8.10.5.
0 Identifies the no data character in the log record.
or
until you exit this menu.
or button until the display flashes on the desired setting.
until you exit this menu.
or
until you exit this menu.
until you exit this menu.
Meaning
button until the display flashes on the desired
button until the display flashes on the desired
Comments
See 8.9.2.2.