Honeywell ADEMCO MX8000 Installation And Operation Manual page 137

LC Sys
VFD Messages
Error Error
✔
Bkup Computer
Trbl
✔
Bkup Computer
Rst
✔
Main Prn Off
Trbl
✔
Main Prn Paper
Out
✔
Main Prn
Restore
✔
Bkup Prn Off
Trbl
✔
Bkup Prn Paper
Out
✔
Bkup Prn
Restore
✔
DC Input Low
Rst
✔
DC Input Low
✔
Msg Que >
Warning
✔
Msg Que <
Warning
✔
LC Run in ROM Line Card Running
✔
Line Fault
Table 7–1: Error Messages (cont'd)
Printer Message
Bkup Computer A communication problem exists between
Trouble the backup automation software and the
receiver.
Bkup Computer The communication error between the
Restore receiver and the backup automation
software has been corrected.
Main Printer Off The port programmed as the primary printer
Line port is off line.
Main Printer Paper The port programmed as the primary printer
Out port is out of paper.
Main Printer The error on the primary printer has been
Restore corrected.
Bkup Printer Off The port programmed as the backup printer
Line port is off line.
Bkup Printer Paper The port programmed as the backup printer
Out port is out of paper.
Bkup Printer The error on the backup printer has been
Restore corrected.
DC Input Low The backup DC power supply trouble has
Restore been corrected.
DC Input Low The backup battery is checked continually
every second. This message would be
displayed if the backup battery setting were
set to "DC Bkp". See Section 5.4.4.
Indicates a low when the voltage drops to
10.2 VDC or lower.
Message Queue When the message queue reaches the
Warning programmed level mark, this message is
given as a pre-warning to "Message Queue
Full". See Section 5.4.5.1 to program the %
level at which the receiver will indicate the
warning.
Message Queue This message is given when the message
Warning Restore queue drops below the programmed level
after a message queue warning indication
has displayed. See Section 5.4.5.2 to
program the % level.
The line card is not running the application
ROM Code code.
Line Fault The phone line voltage has dropped below
the threshold voltage as programmed. (See
Section 5.5.2.3.)
Section 7 – Troubleshooting
Description What to Do
Check cable
connections. Verify
that the port is
configured properly.
Check cable
connections. Verify
that the port is
configured properly.
Check power to
printer.
Replace paper in
printer.
Check cable
connections. Verify
that the port is
configured properly.
Check power to
printer.
Replace paper in
printer.
Restores at 12VDC
after a low battery
condition.
Check the connection
to the DC power
supply. Verify the
output from DC
power supply.
Verify that messages
are acknowledged to
any printers,
automation software,
and while in manual
mode.
Replace the line card.
Check phone line
outlet and phone
cord.
7–3