Honeywell ADEMCO MX8000 Installation And Operation Manual page 182

MX8000 Installation and Operation Guide
Program Mode
Choices
Options
System Options
General
Options
(continued)
Message
Queue Opt.
Slave List
(Shown on
Master
Receiver Only)
Virtual
Receiver/Line
Numbers
A–4
Table A–1: Programming Quick Chart
Choices Choices
No Battery Bkp
Battery Backup
Battery Bkp
Cfg
DC Bkp
Receiver Mode MstrAuto,
MstrPrn,
SlvAuto,
SlvPrn, or
Single
Receiver ID 01-99
Strip Bad
Bad Block
Send Bad
Off
Auxiliary Relay
On
60 Hz
Clock Source 50 Hz
Internal
On 10 to 99%
Off 01 to 90 %
Event Release 1, 20 to 120
sec.
Add Slave 2-digit Slave
No.
View Slave S01=8000
Slave
S02=8000
Slave
Delete Slave S01=8000
Slave
S02=8000
Slave
Receiver 2-digit Virtual
Number Receiver #
3-digit Virtual
Line Number
Line #
(cont'd)
Choices
Yes or No See Section 5.4.4.1 for details.
Yes or No See Section 5.4.4.1 for details.
Yes or No No charging current. See Section 5.4.4.1
for details.
See Section 5.4.4.2 for details.
If this is selected an indicator will be sent
to the automation computer that indicates
a bad data block was received.
Same as Strip Data except the bad data
block is sent with the indicator.
See Section 5.4.4.5 for details.
Set the percentage of how full the
message queue must be before a
"Message Queue Warning" will occur.
Default = 75%.
What percentage the queue must go back
down to before "Message Queue Warning
Restore" message will be sent. Default =
50%.
Time from call beginning until events
released to system.
Enter 8000 receiver number as a 2-digit
entry.
View 8000 receiver slave numbers.
Delete 8000 receiver slave numbers.
See Section 5.4.7 for details.
See Section 5.4.7 for details.
Comments