Table of Contents
Advertisement
Section 2 Agency Requirements
2.1
Telephone Requirements
If requested by the telephone company, the following information must be provided before connecting this
device to the phone lines:
This device may not be connected directly to coin telephones or party line services.
The telephone company may make changes in its facilities, equipment, or procedures that could affect the
operation of the equipment. If this happens, the telephone company will provide advance notice to allow you
to make the necessary modifications to maintain uninterrupted service.
2.2
FCC Statement
FCC Class B
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• reorient or relocate the receiving antenna.
• increase the separation between the equipment and receiver.
• connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• consult the dealer or an experienced radio/TV technician for help.
2.3
Industry Canada Statements
This Class B digital apparatus complies with Canadian ICES-003.
Cet Appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
NOTICE: The Industry Canada Label identifies certified equipment. This certification means that the
equipment meets telecommunications network protective, operational and safety requirements as prescribed
in the appropriate Terminal Equipment Technical Requirements document(s). The Department does not
guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of
the local telecommunications company. The equipment must also be installed using an acceptable method of
connection. The customer should be aware that compliance with the above conditions might not prevent
degradation of service in some situations.
A.
Manufacturer:
B.
Model Number:
C.
FCC Registration Number:
D.
Type of jack (to be installed by the
telephone company):
Ringer equivalence:
Honeywell International Inc.
MX8000
US5GBOT01B46056
RJ31X or RJ11X
0.1B
2–1
Advertisement
Table of Contents
Troubleshooting
