Clear Device; View Devices; Figure 5-30: Visual Steps To Clear A Line From The Receiver - Honeywell ADEMCO MX8000 Installation And Operation Manual

MX8000 Installation and Operation Guide
5.5.6

Clear Device

To Clear or Delete a Device From the Receiver Follow These Steps:
1. Enter Program Mode (see section 5.1).
2
2. Press for Line Device menu.
1
3. Press (MX8000–LC3),
3
(MX8000–LC3) to select your line card type.
4
4. Press to clear a Device.
5. When display shows the list of Devices (see Figure 5–30)
press the until the desired Line is highlighted with
an equal sign.
Note: The MX8000–LC3 shown in Figure 5–30 is an
example only. The display will contain the number of the
line card you are clearing.
ENTER
6. Press .
MENU
The display will read
Note: The MX8000–LC3 shown above is an example only. The display will contain the number of the line
card you are clearing.
7. Press the until Yes is flashing.
ENTER
8. Press .
MENU
9. To exit press .
5.5.7

View Devices

To view all the Lines in the receiver follow these steps:
1. Enter Program Mode (see section 5.1).
2
2. Press for Line Device menu.
1
3. Press (MX8000–LC3),
5
4. Press to view Devices.
5. When display shows the list of Devices (see Figure 5–30) press the
Devices.
6. To exit press .
5–70
2
(MX8000–LC3), or
<Warning!>
LC01 MX8000–LC3
Delete Record No
2
(MX8000–LRR), or
<Clear Device>
D01=MX8000-LC3
D02 MX8000-LC3
D03 MX8000-LC3
< WARNING! >
LC01 MX8000-LC3
Delete Record
Figure 5–30: Visual Steps to Clear a Line
From the Receiver
3
(MX8000–LC1) to select your line card type.
to scroll through the list of
ENTER
¯
MENU
No