Table of Contents
Advertisement
5. Press the
or
ENTER
6. Press
.
MENU
To Exit:
Press
until you return to the main menu.
5.4.5
Message Queue Options
Set the percentage of how full the message queue must
be before a "Message Queue Warning' and "Message
Queue Warning Restore" occur. See Section 7 for
trouble messages.
Note: The "Warning On" can be set from 10% to 99%;
the "Warning Off" can be set from 1% to 90%. A mini-
mum separation of 5% will be set between the On % and
the Off %. For example, if the "Warning On" is set to
82% the "Warning Off" maximum setting can be 77%.
5.4.5.1
Set the Message Queue Warning On level
Set the percentage of how full the message queue can get before the receiver indicates a "Message Queue
Warning" condition.
1. Enter program mode. (See Section 5.1.)
1
2. Press
for general options.
5
3. Press
for message queue options.
4. Enter the level (in %) you wish the receiver message queue to get before it will indicate a message queue
warning.
ENTER
5. Press
.
MENU
To Exit:
Press
until you return to the main menu.
5.4.5.2
Set the Message Queue Warning Off Level
Set the percentage level where the receiver will indicate a restore condition for a "Message Queue Warning".
1. Enter program mode. (See Section 5.1.)
1
2. Press
for general options.
5
3. Press
for message queue options.
4. Press
until the display flashes on the Off field.
5. Enter the level (in %) you wish the receiver message queue to get before it will indicate a message queue
warning restore.
ENTER
6. Press
.
MENU
To Exit:
Press
until you return to the main menu.
button until the display flashes on the desired setting.
Section 5 – Programming
<General Options>
5=Msg Queue Opt.
6 Slave List
7 Virtual Receiver
<Msg Queue Menu>
Wrn Lvl On:75 Off:50
Event Release:
060
<%Wrng On <=Exit >
Figure 5–9: Message Queue Display
¯
5–25
Advertisement
Table of Contents
Troubleshooting
