Table of Contents
Advertisement
MX8000 Installation and Operation Guide
Set for 3/1 and 4/1 Partially Extended Formats:
1. Follow the procedures in Section 5.5.4.
2
2. Press
for pulse format menu.
3. Press
until the display flashes on the Part Ex field.
4. Select the format by pressing the
5. When the desired wait time is flashing press
5.5.4.3
Line Options
Line options is used to set the type of phone line,
number of ring, ring on/off duration, threshold
voltage, and sample time.
Note: Setting the number of rings to 0 disables
the line device.
How to Set the Line Card for a Direct Line (Dedicated Line):
Note: This option must only be chosen for panels that have a direct connect capability. The panel supplies all
line bias and a PBX is not required. This options sets the line card for a dedicated mode where the line is
dedicated to the panel and normal timeouts will not occur.
1. Follow the procedures in Section 5.5.4.
3
2. Press
for Line Options menu.
3. The display will flash on the Direct field.
4. Press the
or
5. When the desired setting is flashing press
To Change the Number of Rings, Follow These Steps:
This controls the number of rings the receiver needs to see before it will answer the call.
1. Follow the procedures in Section 5.5.4.
3
2. Press
for Line Options menu.
3. The display will flash on the Rings field.
4. Enter the desired value from the keypad (000-255) or press the
number of rings before the receiver will answer.
Note: Setting the number of rings to 0 disables the line device.
5. When the desired number of rings is flashing press
Notes:
•
It is recommended that the number of rings is not set to a value greater than 5.
•
If Caller ID (see Section 5.5.4.5) is turned on the number of rings must be set to 2.
5–60
or
ENTER
MENU
button to between Y for Yes, or N for No.
ENTER
MENU
button.
or
.
<Edit Line :01>
3=Line Options
4 Listen In
5 Misc. Line Opt.
Direct=N Rings=002
On=010 Off=010 dB=Md
Thresh=08 Sample=020
<Direct Cnct <=Exit>
Figure 5–25: MX8000–LC1 Line Options Menu
or
.
or
ENTER
or
.
MENU
¯
button to change the
Advertisement
Table of Contents
Troubleshooting
