Checking The Setup; Peer-To-Peer Printing - Konica Minolta IC-206 User Manual

Network printing
4.2

Checking the setup

This section provides an overview of the setup procedure that is required for
each network printing method.

Peer-to-peer printing

1
Connect the network cable. (Refer to "Connecting to a local area
network (LAN)" on page 2-16.)
2
From the machine's control panel, specify the IP address, subnet mask
and default gateway. (Refer to "Specifying an IP address" on
page 4-12.)
3
Print the settings information, and then check the settings. (Refer to
"Printing the settings information" on page 4-17.)
4
Install the printer driver. The Peer-to-Peer Utility is installed when the
printer driver is installed.
– For details on installing the PCL driver, refer to "Installing the printer
driver by using the Add Printer Wizard" on page 3-18.
– If the GDI driver is to be installed, refer to the user manual for the
GDI printer controller, included with this machine.
5
Add the network port to the computer. (Refer to "Connecting the
computer and this machine over a network" on page 4-18.)
Reminder
When installing the printer driver on an operating system other than
Windows 98 SE or Windows Me, the Peer-to-Peer Utility is not installed.
IC-206
4
4-9