Adding The Sipi To The System - Avaya S8400 Installing And Configuring

Chapter 5: IP interface translations
3. If the information in the Subnet Address field is not correct, use the Maintenance Web
Interface to change the media server configuration to match the Server IP address in
configure server. Under Server Configuration and Upgrades, click Configure Server
to change the media server configuration. Then return to this procedure.
4. Set the Switch Identifier field to the switch ID letter (A through J; A is the default setting).
5. Set the IPSI Control of Port Networks field to enabled.
6. Press Enter to save the translations.

Adding the SIPI to the system

The information on this screen differs, depending on whether the SIPI IP addresses are static,
or assigned automatically through DHCP.
1. Type add ipserver-interface PNnumber and press Enter.
2. In the Host field, enter the IP address for the SIPI in the port network listed in the Location
field.
add ipserver-interface 8
IP SERVER INTERFACE (IPSI) ADMINISTRATION - PORT NETWORK 8
Ignore Connectivity in Server Arbitration? n
Primary IPSI
------------
Location:
Host: 172.22.22.174
DHCP ID: ipsi-A01a
3. Set the IP Control field to y.
4. Verify that all the other fields are populated.
5. Press Enter to save translations.
6. Repeat steps 1 through 5 for each port network.
46
Installing and Configuring the Avaya S8400 Media Server
IP Control? y
1A01
Socket Encryption? n
Enable QoS? n
QoS Parameters
--------------
Call Control 802.1p: 6
Call Control DiffServ: 46
February 2006