Avaya S8400 Installing And Configuring page 85

Troubleshooting for media server hardware configuration (continued)
Problem
LED display on SIPI
is flashing
Cannot access SIPI
for static addressing
No "V" on SIPI LED
"V" on SIPI LED is not
filled in
Get alarm when first
connect to SIPI
Installing and Configuring the Avaya S8400 Media Server
Troubleshooting configuring the media server hardware
Possible solution
SIPI LED has not had an IP address assigned to it (static IP
●
addressing)
Make sure you are plugged into the Services (top) port on the
●
SIPI.
Make sure the ARP cache is cleared on the laptop. In an
●
MS-DOS command window, type arp -d 192.11.13.6 and
press Enter.
SIPI is not connected to Ethernet switch or network.
●
Connectcrossover cable between the RJ45 SIPI adapter and
Eth-A on the S8400 adapter, or, connect cable to bottom port on
faceplate and to the Ethernet switch or the customer's network.
SIPI does not have an IP address assigned to it.
●
SIPI has not been administered.
●
SIPI does not have current firmware. Upgrade firmware.
●
2 of 2
85
February 2006