Enabling Sipi - Avaya S8400 Installing And Configuring

1. Type add cabinet n (where n is the cabinet number) and press Enter for each stack of
Media Gateways controlled by one TN8412AP SIPI circuit pack.
A cabinet is defined as up to five G650 Media Gateways mounted in a rack and
TDM-connected.
2. Fill in the location and carrier type for media gateways 2(B), 3(C), 4(D), and 5(E).
add cabinet 1
CABINET DESCRIPTION
Cabinet Layout: G650-rack-mount-stack
Number of Portnetworks: 1
Survivable Remote EPN? n
Cabinet Holdover: A-carrier-only
CARRIER DESCRIPTION
Carrier
E
D
C
B
A

Enabling SIPI

These steps enable the SIPI circuit pack and allow the SIPI to control the port network.
1. Type change system-parameters ipserver-interface and press Enter.
2. On the IP Server Interface System Parameters screen, verify that the Primary Control
Subnet Address is correct.
The subnet address must match the most significant 3 octets (the first 3 groups of digits in
the subnet address) of the Media Gateway's Server IP address (the server that controls
the port network). Use configure server on the Maintenance Web Interface to see the
IP address to match.
An asterisk (*) to the right of the Subnet Address field means that the subnet address
displayed is not the correct one. Avaya Communication Manager does not have the subnet
information.
Installing and Configuring the Avaya S8400 Media Server
Cabinet: 1
Cabinet Type: expansion-portnetwork
Location: 1
Room:
Carrier Type
not-used
not-used
not-used
G650-port
G650-port
CABINET
IP Network Region:1
Floor:
Number
PN 09
PN 09
PN 09
PN 09
PN 09
Enabling SIPI
Page 1 of 1
Building:
February 2006
45