Ricoh SP C250SF Operating Instructions Manual page 332

10. Troubleshooting
Error Code
1XXX32 to 1XXX84
2XXX14
2XXX32 to 2XXX84
330
An error occurred while sending a fax.
• Check if the telephone line is properly connected to the
machine.
• Disconnect the telephone line cord from the machine,
and connect the cord to a telephone. Check if you can
make calls using the telephone. If you cannot make calls
this way, contact your telephone company.
• If the problem persists, contact your sales or service
representative.
The machine was not able to print the received fax, or the
machine's memory reached its capacity while receiving a fax
because the document was too large.
• The paper tray was empty. Load paper in the paper tray.
See page 71 "Loading Paper".
• The tray selected in [Select Paper Tray] under [Fax
Features] did not contain A4, Letter, or Legal size paper.
Load valid size paper in the tray, and configure the
paper size settings under [Tray Paper Settings]
accordingly.
• A cover or tray was open. Close the cover or tray.
• There was a paper jam. Remove the jammed paper. See
page 295 "Removing Paper Jams".
• A print cartridge was empty. Replace the print cartridge.
See page 273 "Replacing the Print Cartridge".
• The received fax was too large. Ask the sender to re-send
the document in parts as several smaller faxes, or to send
the fax at a lower resolution.
An error occurred while receiving a fax.
• Check if the telephone line is properly connected to the
machine.
• Disconnect the telephone line cord from the machine,
and connect the cord to a telephone. Check if you can
make calls using the telephone. If you cannot make calls
this way, contact your telephone company.
• If the problem persists, contact your sales or service
representative.
Solution