Chapter 6. Ethernet-Based Remote Product Management; Introduction; Ethernet Management Interface Protocols - Comtech EF Data CDM-625 Installation And Operation Manual

Advanced satellite modem (18 kbps – 25 mbps)

Hide thumbs Also See for CDM-625:

Table of Contents

Chapter 6. ETHERNET-BASED

The CDM-625 Advanced Satellite Modem base unit is equipped with four RJ-45 10/100 BaseT

Ethernet connectors, subject to the following conditions:

When Dedicated Management is disabled, you may use any port for Ethernet-based

remote product management (monitor and control) purposes.

When Dedicated Management is enabled, you may use only that specific port for remote

monitor and control (M&C) purposes.

The user PC facilitates access to Ethernet-based remote M&C of the CDM-625 through three

separately-operated protocols:

Simple Network Management Protocol (SNMP) – This requires a user-supplied Network

Management System (NMS) and a user-supplied Management Information Base (MIB) File

Telnet Interface – This requires use of a user-supplied terminal emulation program such as

HyperTerminal (for use with the remote control protocol) or PuTTY (for use with the Telnet

Command Line Interface), installed on the user PC.

CDM-625 Web Server (HTTP) Interface – This requires a compatible user-supplied web

browser such as Internet Explorer, installed on the user PC.

REMOTE PRODUCT