Ethernet Network Configurations In Router Mode (With Ip Packet Processor); Router Multipoint Hub Configuration; Figure 16-10. Point-To-Multipoint (Router Multipoint Hub Mode) - Comtech EF Data CDM-625 Installation And Operation Manual

Advanced satellite modem (18 kbps – 25 mbps)

Hide thumbs Also See for CDM-625:

Table of Contents

CDM-625 Advanced Satellite Modem

Ethernet Network Configuration

16.4 Ethernet Network Configurations in Router Mode (with IP Packet

Point-to-Multipoint (Router Multipoint Hub) Mode

Figure 16-10 depicts a Point-to-Multipoint (Router Multipoint Hub) setup, with the optional IP

Packet Processor installed and enabled in the CDM-625 and configured for Router Mode. This

configuration features a Hub Outbound CDM-625, with a rack of Hub Demods (Rx-only

CDM-625s are connected on single LAN networks), and Remotes (each) connected to a separate

LAN network).

To configure a Router Multipoint Hub Network:

For the "Hub Outbound" Modem Configuration:

o Referring to Sect. 6.5.4.3.2.1 Configuration | LAN | IP in Chapter 6. ETHERNET-

o Referring to Sect. 6.5.4.3.3.1 Configuration | Routing | Routes in Chapter 6.

BASED PRODUCT MANAGEMENT: From the page's Network Configuration

section, use the Working Mode drop-down menu to select the mode as Router

Multipoint Hub, and then click [Submit] to accept this configuration change.

ETHERNET-BASED PRODUCT MANAGEMENT: From the page's Add New Route