Table of Contents
Advertisement
CDM-625 Advanced Satellite Modem
Front Panel Operation
•
APC,Side B,C-band
•
APC,Side B,Ka-band
With no CnC module (card) installed, CnC Mode is 'Off', this menu is inaccessible, and the
CONFIG: CnC → Mode screen appears as shown:
CnC Mode:
5.2.1.8.2 CONFIG: CnC CONFIG: CnC Freq-Offset
CnC Frequency Offset:
Use this menu to enter the maximum expected frequency offset between the outbound
interferer and the desired inbound. It normally corresponds to the demod acquisition range.
Use the
arrow keys to edit the CnC Frequency Offset value, and then press ENTER. The
▲▼
upper limit of Frequency Offset is determined by the Rx symbol rate:
Below 64 ksymbols/sec:
•
•
Between 64 and 389 ksymbols/sec: ± 1 up to a maximum of ± 32kHz
•
Above 389 ksymbols/sec: ±1 to ± (0.1Rs) kHz, up to a maximum of ± 200 kHz
This range is pre-calculated and displayed in parentheses for reference.
5.2.1.8.3 CONFIG: CnC Search-Delay
CnC Search Delay:
To reduce the time taken for the CnC algorithm to converge, you may apply restrictions to the
range of delay used by the search. During initial link testing, it should be set to 240 ms (min) and
300 ms (max). Once CnC has found the exact delay, the value can be further reduced but care
should be taken to allow sufficient range to accommodate changes in path delay due to
Doppler.
If CnC is being bench-tested with two units in a back-to-back configuration, the
minimum delay should be set to 0 ms, and the maximum to 20 ms. This takes into
account the lack of satellite delay.
•
APC,Side B,X-band
Off
(Off, On, APC)
Card not installed
±1 to ±(Rs/2) kHz
Rs=symbol rate in ksymbols/sec
Min: 010 ms
Max: 290 ms
(range 1-032)
+/-015 kHz
, where:
(range 0-330ms)
5–38
Revision 13
MN-CDM625
• APC,Side B,Ku-band
()
()
()
Advertisement
Table of Contents
