Optional Dc Operation – Replacing Fuses; Figure 3-12. Replacing Cdm-625 Optional Dc Chassis Fuses - Comtech EF Data CDM-625 Installation And Operation Manual

Advanced satellite modem (18 kbps – 25 mbps)

Hide thumbs Also See for CDM-625:

Table of Contents

CDM-625 Advanced Satellite Modem

Rear Panel Connectors and Pinouts

Optional DC Operation – Replacing Fuses

For DC operation the CDM-625 requires two different fuses that are contained within the

individual screw-in receptacles below the terminal block (located on the rear panel, Figure

To replace the fuses:

DISCONNECT THE POWER SUPPLY BEFORE PROCEEDING!

First, unscrew either fuse holder from its receptacle. Then, remove and replace the modem

and/or the BUC fuse(s):

o Use T3A (3 Amp) 250V fuses for modem operation (left-hand receptacle).

o Use T6.3A (6.3 Amp) 250V fuses when a Block Upconverter (BUC) is installed (right-hand

receptacle).

Screw either fuse holder back into its receptacle.

FOR CONTINUED OPERATOR SAFETY, ALWAYS REPLACE THE FUSES WITH

THE CORRECT TYPE AND RATING.