Additional Pv Display (Puad); Additional Temperature Input Shift Value Display (Isdp); Alarm 1 Latch (A1Lt), Alarm 2 Latch (A2Lt), Alarm 3 Latch (A3Lt) - Omron E5ZN Operation Manual

Advanced Function Setting Level
7-6-15 Additional PV Display (pUad
Function
Communications
Settings
7-6-16 Additional Temperature Input Shift Value Display (isdp
Function
Communications
Settings
7-6-17 Alarm 1 Latch (a1lt
Alarm 2 Latch (a2lt
Alarm 3 Latch (a3lt
Function
pUad)
pUad pUad
• This parameter enables displaying only the PV. It is added to the top of
the operation level of the E5ZN-SDL Setting Display Unit. It is used to
give the option of displaying the PV and SP, or just the PV only.
• Setting changes to "additional PV display" must be enabled by executing
a software reset or by turning ON the power again.
ch
Shared C3
Setting range
00000000H to 00000001H
0: Not added (off)
1: Added (on)
• This parameter stops the display of the temperature input shift value in
the E5ZN-SDL Setting Display Unit operation level. The shift function is
enabled even when this parameter is set to "no display. "
• Setting changes to "temperature input shift value display/not display"
must be enabled by executing a software reset or by turning ON the
power again.
ch
Shared C3
Setting range
00000000H to 00000001H
0: No display (off)
1: Display (on)
a1lt a1lt) a1lt
a2lt)
a2lt a2lt
a3lt)
a3lt a3lt
Condition: The alarm type must be set to other than "no alarm."
• When these parameters are set to ON, the latch function is added to the
alarm functions. This means that once the alarm function has turned ON,
the alarm output function is held ON until the power is turned OFF. The
latch is canceled if setting area 1 is switched to.
• When alarm output function is set to "open for alarm," the closed output is
held, and when set to "close in alarm," the open output is held.
• Setting changes to "alarm 1 to 3 latch" must be enabled by executing a
software reset or by turning ON the power again.
Variable type
0029 or 0129
Variable type
002A or 012A
Section 7-6
Address
Unit Default
- 0: Not added
isdp) isdp isdp
Address
Unit Default
- 0: No display
143