Advanced Function Setting Level; Parameter Initialize (Init); Number Of Multi-Sp Uses (Eu-M); Event Input Assignment (Eu) - Omron E5ZN Operation Manual

Advanced Function Setting Level

7-6

Advanced Function Setting Level

7-6-1 Parameter Initialize (init
Function
Communications
Example of Use
7-6-2 Number of Multi-SP Uses (eU-m
Function
Communications
Settings
7-6-3 Event Input Allocation (eU
Function
Communications
init init) init
This parameter returns all settings to their defaults.
Use the "parameter initialize" operation command. Refer to page 82 for infor-
mation.
ON (on): Initializes all parameters.
OFF (off): Turns OFF the E5ZN after returning parameter settings to their
defaults.
eU-m)
eU-m eU-m
• This parameter sets the multi-SP set points that are used for the event
input.
• When the number of multi-SP uses setting has been changed, the setting
must enabled by executing a software reset or by turning ON the power
again.
ch
Shared C3
00000000H to 00000001H
0: No multi-SP
1: SP0/1
eU) eU eU
Condition: The number of multi-SP uses must be set to "0."
• By selecting this parameter to "RUN/STOP," an external signal can be
used to control RUN/STOP status.
• Settings are not possible when the "number of multi-SP uses" parameter
is set to 1 (2: multi-SP).
• Setting changes to event input allocations must be enabled by executing
a software reset or turning ON the power again.
ch
Shared C3
Variable type
Setting range
Variable type
Section 7-6
Address
0017 or 0117
Unit Default
- 0: No
multi-SP
Address
0018 or 0118
135