Write Mode - Omron E5ZN Operation Manual

Commands and Responses

5-9-11 Write Mode

Command
Response
78
Command Related
MRC SRC
code information
"30" "05" "04"
Related information
"00" or "10" Backup mode
"01" or "11" RAM write mode
This command selects backup mode and RAM write mode.
Default is RAM write mode.
This command can be used in either setting area 0 or 1.
Before executing the command, use an operation command to enable com-
munications writing.
Write mode
Backup mode When operation/adjustment level setting data write has been
performed via communications, the data is written to internal
non-volatile memory. Refer to 6-3 Setup Level Configuration
and Front Panel Keys for information on operation/adjustment
level.
RAM write mode When operation/adjustment level setting data write has been
performed via communications, the data is not written to inter-
nal non-volatile memory. However, if the data is changed using
the E5ZN-SDL Setting Display Unit key operations, it is written
to internal non-volatile memory. Refer to 6-3 Setup Level Con-
figuration and Front Panel Keys for information on operation/
adjustment level.
When switching from RAM write mode to backup mode, the operation/adjust-
ment level setting data is written to internal non-volatile memory. Refer to 6-3
Setup Level Configuration and Front Panel Keys for information on operation/
adjustment level.
Response code
MRC SRC
"30" "05" "0000"
Response code: The code shown above represents normal completion. For
details on the response code, refer to 5-7 Operation Commands .
Contents
Description
Section 5-9