Decimal Point (Dp); C/ ° F Selection (D-U) - Omron E5ZN Operation Manual

Initial Setting Level
7-5-2 Scaling Upper Limit (in-h
Scaling Lower Limit (in-l
Decimal Point (dp
Function
Communications
Settings
See Also
° ° ° ° C/ ° ° ° ° F Selection (d-u
7-5-3
Function
Communications
Settings
in-h)
in-h in-h
in-l)
in-l in-l
dp) dp dp
Condition: The input type must be set to analog input.
• These parameters can be used when a voltage input is selected as the
input type.
• When a voltage input is selected as the input type, scaling is performed.
Set the upper limit in the "scaling upper limit" parameter and the lower
limit in the "scaling lower limit" parameter.
• The "decimal point" parameter specifies the decimal point position of
parameters (e.g., set point) whose unit is set to EU.
Setting
Scaling upper limit value
Scaling lower limit value
Decimal point position
Setting
Scaling upper limit Scaling lower limit +1 to 00000270FH
value (Scaling lower limit +1 to 9,999)
Scaling lower limit FFFFF831H to scaling upper limit -1
value (-1999 to scaling upper limit -1)
Decimal point 00000000H to 00000001H (0 t0 1)
position
• Related Parameter
"Input type" (initial setting level) (page 128)
d-u)
d-u d-u
Condition: The input type must be set to temperature input.
• Set the temperature input unit to either °C or °F.
• The temperature input unit must be the same for both ch1 and ch2.
ch
Shared C3
00000000H to 00000001H
°
0: C (c)
°
1: F (f)
ch
1
2
1
2
1
2
Settings range
Variable type
Setting range
Section 7-5
Variable type Address
C3 0001
C3 0101
C3 0002
C3 0102
C3 0003
C3 0103
Unit
-
-
-
Address
0004 or 0104
Unit
-
Default
100
0
0
Default
°
0: C
129