Quick Startup Guide Quick - ADTRAN Express L128T S User Manual

14. If you want the L128T S/T to dynamically assign your computer
an IP address, go into the Configuration/IP/NAT submenu and
set DHCP Mode to On.
15. If you want to statically assign your computer an address on the
network of the L128T S/T's Ethernet, set DHCP mode to Off.
16. Arrow left to save the configuration.
17. Go into the Dial menu.
18. Set the cursor over the Dial parameter for the Connection List
profile you just set up.
19. Press Enter; the Express L128T S/T will start dialing.
20. If the call is successful, the Status column will read active. If not,
make sure the number(s) are correct or reference Troubleshooting
on page 4-1 before going on to the next step.
21. Once the call is up, the PC must generate a DHCP request to
obtain the IP parameters needed to get on the Internet. Refer to
your PC's user manual or help screen.
MULTIPROTOCOL ROUTING BETWEEN TWO
LANS
Remote/Home Office Accessing the Corporate
LAN
The following steps can be used to set up the Express L128T S/T on a
remote LAN to access a corporate or central LAN using demand dial
and dynamic bandwidth management.
1. Connect the 10BaseT cable from the hub to the Express L128T S/T.
Select TO HUB on the Express L128T S/T back panel. The LI
indicator should be illuminated.
2. Set the IP address and Subnet Mask assigned by the network
administrator in the Configuration/IP menu.
3. For the Default Gateway, enter the IP address of the access server
at the remote site. This creates a default route in the IP routing
table that will be used with the dial-on-demand feature in the
Express L128T S/T. Arrow left and save the changes.
61202070L3-20 Express L128T S/T User Manual
Quick Startup Guide
Quick Start-3