Table of Contents
Advertisement
Chapter 1. Understanding ISDN and the Express L128T S/T
If Hang Up is activated from the Dial menu when the link is down, the
retained routes are removed.
The Express L128T S/T can be connected to two WAN destinations at
the same time. Each B-channel is dialed to a different location. Routes
learned from one WAN destination are advertised to the other using
RIP.
IPX Routing
Like IP routing, the Express L128T S/T can connect to two different
sites and exchange IPX packets. Network routes and services are
learned and advertised using Novell's RIP and SAP. Routes and ser-
vices learned from a separate site can be retained in the Express L128T
S/T when the connection goes idle. While retained, the Express L128T
S/T can spoof RIP/SAP and watch-dog and filter serialization packets
that would normally be required between the Novell server and client.
Connection List - Simplifying and Enhancing the Dial Function
The Connection List, which is accessed from the Configuration menu,
provides a location to define information regarding 15 individual des-
tinations that may be dialed. A Connection List entry is required for
each destination since authentication information (method, username,
password), number of B-channels, telephone numbers, Caller ID, IP,
or IPX address (for routed connections), and other information can be
stored for each destination defined. Defined destinations may be di-
aled by selecting the Dial activator in the Dial menu or by demand for
the desired Connection List profile.
Concurrent Routing and Bridging
The Express L128T S/T can route IP and IPX as well as bridge non-IP/
IPX packets simultaneously. The Connection List profile will by de-
fault negotiate PPP network protocols to support the transmission and
reception of IP, IPX, and Bridge packets. If the PPP peer does not ac-
cept a protocol, the Express L128T S/T will fall back to any combina-
tion of routing and bridging.
61202070L3-20
Express L128T S/T User Manual
1-9
Advertisement
Table of Contents
Troubleshooting
