Table of Contents
Advertisement
Chapter 3. Terminal Menu Operation
NAT/DHCP Mode
Write security: 3; Read security: 5
When this option is set to On, the Express L128T S/T acts as a DHCP
server and will dynamically assign IP, network mask, default gate-
way, and DNS addresses to any device which transmits a broadcast
DHCP request. The addresses assigned are based on the Express
L128T S/T's own IP address and will be within the same network.
This mode is most commonly used with the NAT functionality. The
default is Off.
NAT/DHCP Renewal Time
Write security: 3; Read security: 5
This is the number of hours that the DHCP server should allow the de-
vice before it is required to send a new DHCP request. The default is
15 hours, and 0 represents an infinite lease.
NAT/Web Server
Write security: 3; Read security: 5
This is the IP address of a web server on the Ethernet network. When
an active NAT connection is made to the Internet, any HTTP, FTP, or
Mail server requests from the WAN are translated and sent to this web
server.
IP/DNS
The Domain Name Server parameters used by the Express L128T S/T
are specified here. The DNS server addresses can be exchanged be-
tween PPP peers. When a connection occurs and IPCP is negotiated,
the Express L128T S/T will get the DNS server addresses from the PPP
peer. If the configured DNS server addresses (Server 1 and Server 2)
are all zeros, the addresses from the PPP peer are used. In NAT mode,
the PPP peer's DNS addresses are always used. The DNS addresses set
in Server 1 and Server 2 are offered to a PPP peer if so requested.
61202070L3-20
Express L128T S/T User Manual
3-17
Advertisement
Table of Contents
Troubleshooting
