Setting The Motion Area - Honeywell HREP24 User Manual

60 | Performance Series HREP2 DVR User Guide
4.
CAUTION
on the characteristics of the connected camera or the installation
environment.

Setting the Motion Area

From the motion setup window, click EDIT AREA in the right corner to display the area setup
screen. Setting the motion area may differ depending on the camera model. Below is a typical
setting of the motion area.
1.
2.
3.
4.
5.
6.
www.honeywell.com/security
When done, press EXIT on the remote control or click CLOSE at the bottom of the screen.
The confirmation message appears and you will return to the previous menu.
The motion detection sensitivity may differ depending
Click EDIT AREA to open the motion area setup screen (see
Figure 4-6 Setting a Motion Detection Area
If you are using the remote control, press ENTER to mark the current position.
Use the arrow buttons to move to a desired block and press ENTER. The area setup will
begin.
Then, use the arrow buttons to specify the area.
Note Alternatively, you can use the drag-and-drop method to specify or release the
area as using mouse.
If you select the specified area again, it will be released from the selected motion area.
Press EXIT on the remote control or right-click any area to display the popup menu as
shown in Figure 4-6.
While the popup menu is displayed, select Sensitivity to set the motion detection
sensitivity of the channel currently selected (see
Figure 4-6).
Figure 4-7).