Connecting The Pc/Telephone Configuration To The Power Source - Lucent Technologies DEFINITY User Manual

Installation
Connecting the PC/Telephone Configuration
to the Power Source
If you are using an 8411, 64xx-, 74xx-, 84xx-, or 94xx-series telephone, you
must connect the PC/Telephone configuration to a separate power source.
NOTE:
This step is not necessary if you are using a CallMaster VI telephone.
The CallMaster VI is powered by the switch, and does not require a
separate power supply.
If you are using a KS-22911,L2 power source (see Figure 1-6):
1. Plug the 4002B2 Adapter into the PBX wall jack.
2. Plug the remaining end of the D8W cord (from the PC/Telephone
configuration you assembled earlier) into the bottom connector on
the 400B2 adapter.
3. Plug one end of the D6AP cord into the power supply unit.
4. Plug the other end of the D6AP cord into the top connector on the
400B2 adapter.
5. Plug the power supply unit into a 120 VAC, 60 Hz outlet.
1-14
Issue 2.5 October 1999
NOTE:
Make certain that the AC outlet to which you connect the
power supply is unswitched (for example, not controlled by
a wall switch or light dimmer).