Top Panel With Leds - NETGEAR WAC104 User Manual

Top panel with LEDs

The status LEDs are located on the top panel of the AP.
Figure 2. Overview of the LEDs
Table 1. LED descriptions
LED Description
Power Solid green. The AP is ready.
Solid green temporarily, blinking green temporarily, and finally solid green. The
AP is starting or was reset to factory default settings and is restarting. For more
information about resetting the AP to factory default settings, see Return the AP to its
factory default settings on page 55.
Blinking green. The AP is starting or upgrading firmware. If the Power LED is blinking
green at any other time, see Power LED remains blinking green on page 85.
Off. Power is not supplied to the AP.
WPS Solid green. (Wi-Fi Protected Setup) is ready for use. By default, the WPS LED is off.
Blinking green for two minutes. Someone pressed the WPS button on the AP to join
the WiFi network. For more information, see Use Wi-Fi Protected Setup to join the WiFi
network of the AP on page 30.
WiFi Solid green. One or both WiFi radios are operating.
Blinking green. One or both WiFi radios are sending or receiving traffic.
Off. Both WiFi radios are off. For more information, seeControl the WiFi radios on page
43.
LAN Ethernet LAN ports 1–4:
Solid green. A powered-on Ethernet device is connected to the LAN port.
Blinking green. The LAN port is sending or receiving traffic.
Off. No powered-on Ethernet device is connected to the LAN port.
Hardware Overview of the
Access Point
802.11ac Wireless Access Point Model WAC104
10 User Manual