Considerations For Sfc; Table 7 Installing And Charging Sfc Battery Pack - Honeywell ST 3000 User Manual

3.4

Considerations for SFC

Install SFC battery
pack
22 ST 3000 Release 300 and SFC Model STS103 User's Manual
If the SFC battery pack was removed for shipping and/or storage, you
will have to install the battery pack and charge the batteries before you
can operate the SFC.
The procedure in Table 7 outlines the steps for the battery pack.
Table 7 Installing and Charging SFC Battery Pack
Step
Turn SFC face down on working surface. Use metric hex wrench
1
(2.5 mm) to remove screws in battery compartment cover and
remove cover.
2 Insert battery pack in compartment and connect plug in compartment
to pin on battery back
Example - Battery pack installation.
Replace cover and tighten hex screws
3
4 Connect lead from battery charger to recessed connector on left side
of SFC.
WARNING
Always recharge the SFC battery pack in a nonhazardous location.
The SFC itself is an intrinsically safe device.
Action
Battery Pack
The SFC battery charger is not intrinsically safe.
Hex Screws
21004
Continued on next page
6/05