Table 30 Setting Up Local Smart Meter Configuration Using An Sfc - Honeywell ST 3000 User Manual

6.11 Configuring Smart Meter Using SFC,
Procedure, continued
Table 30 Setting Up Local Smart Meter Configuration Using an SFC, continued
Step Press Key
NON-VOL
3
ENTER
(YES)
4
6/05 ST 3000 Release 300 and SFC Model STS103 User's Manual
Read Display or Action
M e t e r C o n f
S F C O R K I N G
W
M e t e r C o n f
M e t e r B d P r
M e t e r C o n f
C o n f i g u r e M e t
Continued
Enters meter configuration function
i g
and confirms that Local Smart Meter
. . .
is present. Timed prompt - Proceed
i g to Step 4.
e s e n t
ATTENTION If prompt "No Meter
Present" appears, prompt times out
in a few seconds, as described
above, and calls up the Configure
Meter? prompt. This means that
you can access the meter
configuration function without the
Local Smart Meter installed.
Proceed to Step 4. If prompt "Mtr
not Supportd" appears, prompt
times out and returns to previous ST
CONFIG prompt (See Step 2.). This
means that you are working with a
pre-release 300 transmitter that
does not support the Local Smart
Meter option and, therefore, can not
access the meter configuration
function.
Prompt asks if you want to configure
i g
Local Smart Meter. If you want to
e r ?
configure it, go to Step 5. If you do
not want to configure it, press [
key to exit function.
Description
]
CLR
Continued on next page
99