Figure 20 Write Protect Jumper Location And Selections - Honeywell ST 3000 User Manual

5.3 Making Initial Checks,
Analog and DE
modes, continued
Software version
compatibility
Write protect option
Figure 20 Write Protect Jumper Location and Selections.
Failsafe
Direction
Jumper
56 ST 3000 Release 300 and SFC Model STS103 User's Manual
A transmitter in the digital (DE) mode can communicate in a direct
digital fashion with Honeywell's TPS system and Allen-Bradley PLCs.
The digital signal can include process variable as well as configuration
database data depending upon the broadcast format selected during
configuration.
The SFC model STS103 with software version 5.0 or greater is fully
compatible with all Series 100 and Series 900 Release 300 transmitters.
The SFC will operate with transmitters that have older software
versions, but functions will be limited to those applicable for the
transmitter software.
The ST 3000 transmitters are available with what is called a "write
protect option". It consists of a jumper located on the transmitter's PWA
that you can position to allow read and write access or read only access
to the transmitter's configuration database. When the jumper is in the
read only position, you can only read/view the transmitter's
configuration and calibration data. Note that the factory default jumper
position is for read and write access. There is no need to check the
jumper position unless you want to change it.
Figure 20 shows the location of the write protect jumper on the PWA for
Release 300 transmitters.
Continued
W
R
Read and
Write
Read Only
Power
Connector
Meter
Connector
6/05