Honeywell ST 3000 User Manual page 179

8.6 Monitoring Local Smart Meter Display,
Display description,
continued
Table 50 Description of Display Indicators Shown in Figure 51, continued
Display Indicator
KNOWN VALUE
ANALOG
inH2O
K
GPH
GPM
mmHg
PSI
A
Stick-On Label (not shown)
Typical operation
indications
6/05 ST 3000 Release 300 and SFC Model STS103 User's Manual
The Upper Value or Lower Value being displayed has previously
been configured to the value shown.
Transmitter is in its Analog mode. (When indicator is OFF,
transmitter is in its DE mode)
Inches of Water is selected engineering units for digital readout
Multiplies digital reading by 1,000. Turns on automatically when
reading exceeds 1999.
Gallons per hour is selected engineering units for digital readout.
(Note that the FLOW indicator must also be lit to allow this
selection.)
Gallons per minute is selected engineering units for digital
readout. (Note that the FLOW indicator must also be lit to allow
this selection.)
Millimeters of Mercury is selected engineering units for digital
readout.
Pounds per Square Inch is selected engineering units for digital
readout.
Transmitter is absolute pressure type. Digital readout represents
absolute values.
Selected engineering unit equals one of these units which is
available as a stick-on label from Honeywell drawing number
30756918-001.
Kpa
Mpa
mbar
bar
g/cm2
Kg/cm2
mmH2O = Millimeters of Water
inHg
mH2O
Table 51 summarizes typical Local Smart Meter indications. Note that
other combinations of status messages are possible.
What It Means When Lit
= Kilopascals
= Megapascals
= Millibar
= Bar
= Grams per Square Centimeter
= Kilograms per Square Centimeter
= Inches of Mercury
= Meters of Water
Continued
Continued on next page
165