Saving And Restoring A Database - Honeywell ST 3000 User Manual

8.5

Saving and Restoring a Database

Background
Figure 50 Summary of Save and Restore Database Function.
Saved Configuration Database
ID
PT 3011
Output Form
LINEAR
Damping Time
2.0 sec.
LRV
35.0 psi
URV 200.0 psi
Output Signal Mode SINGLE RNG
6-BYTE
Message Format
Read only
Failsafe Mode
Working
Memory
ST 3000
160 ST 3000 Release 300 and SFC Model STS103 User's Manual
If it ever became necessary to replace a damaged transmitter with a
spare, you could save the configuration database from the damaged
transmitter to the HOLD memory in the SFC and then restore the saved
configuration database from the HOLD memory in the spare transmitter.
In fact, you could restore the saved configuration database in any
number of transmitters as long as you change the tag number (ID) in the
restored database.
NOTE: The configuration data for the optional Local Smart Meter is
stored in a memory located on the transmitter's PWA. If a database
save and restore is done with the SFC, then the meter configuration is
restored along with the transmitter configuration.
Figure 50 shows a graphical summation of the save and restore database
function.
SAVE
Restored Configuration Database
Output Form
Damping Time
Output Signal Mode
Message Format
Failsafe Mode
Hold
Memory
RESTORE
SFC
ID PT 3011
LINEAR
2.0 sec.
LRV 35.0 psi
URV 200.0 psi
SINGLE RNG
6-BYTE
Read Only
Working
Memory
ST 3000
Continued on next page
6/05