Log-In And Log-Out; Log-In - Panasonic WJ-SX150 Operating Instructions Manual

LOG-IN AND LOG-OUT

Before starting the following procedures, all system compo-
nents must be turned on.
The following procedures are applicable when the system
controller is connected to the unit.

Log-in

This operation is skipped when the auto log-in is set to ON.
(Refer to p. 73.)
1. Turn on the power switches of all system components.
The OPERATE indicator will light up.
2. To turn on the power of the system controller, connect
the AC adapter to the AC outlet.
The LINK indicator lights up and "NO USER" appears
on the LED display of the system controller.
3. To select your registered operator ID number (1 to 16,
up to 2 digits), press the numeric buttons, then press
the CAM (SET) button.
The underline appears on the LED display of the con-
troller.
The factory default setting is 150.
4. To select your registered password (up to 5 digits),
press the numeric buttons, then press the CAM (SET)
button.
The factory default setting is 150.
If the operator ID and password are correct, "READY"
will appear on the LED display.
72
T&D CAM ID EVENT
AUX1 OFF AUX1 ON
STILL
MON STATUS ALL
EL-ZOOM AUX2 OFF AUX2 ON
ALM H VLD H SYS S
DEF OFF DEF ON
SEQUENCE
MON (ESC) CAM (SET)
MON LOCK WIPER
MULTI SCREEN SEL
Note: If an operator ID or password error occurs, the
PROHIBITED indicator on the controller will blink
and "NO ACCESS" will blink on the LED display for
about 3 seconds. Then "NO USER" appears on the
LED display. Return to step 3 and select your oper-
ator ID.
Note: If the auto log-in is set to ON, any operator can login
automatically. After the controller is turned on, "AUTO"
appears on the LED display for approximately 2 sec-
onds, then "READY" automatically appears.