Specifying Administrator Forwarding Settings (Mode 198) - Konica Minolta BIZHUB 350 User Manual

Specifying management settings

Specifying administrator forwarding settings (mode 198)

You can specify whether a received document is forwarded to a destination
specified by the administrator.
Factory settings
Bit
Setting
Specifying settings
The shaded cells represent the factory settings. The page numbers on the
right refer to the descriptions of the corresponding functions.
Bit
7
6
5, 4
3, 2, 1, 0
(*) Bit 7 of mode 198 is enabled only when "1 (transmit)" is specified.
200/250/350
7 6 5 4 3 2 1 0
1 1 0 1 0 0 0 0 (HEX: D0)
Description
Specifies whether a received
document is forwarded to a
destination specified by the
administrator.
Specifies whether to enable
TX Forwarding when scan-
ning.(*)
Specifies the print condi-
tions of transmission reports
for TX Forwarding.(*)
-----------------------------
Setting Description
0 Not forwarded
1 Forwarded
0 Not forwarded
1 Forwarded
00 Not output
01 Undeliverable
10 Always prints
11 *Do not specify these set-
tings.
*
0000 Do not change these bits.
9
Page ref-
erence
page 9-22
---------
---------
---------
9-37