Specifying management settings
Specifying whether to enable access locks, and whether to enable the
password rules (mode 469)
Specify whether to lock access if the password is entered incorrectly, and
specify whether to apply the password rules.
Factory settings
Bit
Setting
Specifying settings
The shaded cells represent the factory settings. The page numbers on the
right refer to the descriptions of the corresponding functions.
Bits
7
6, 5
4
3, 2, 1, 0
Note
For the Failed Access Penalty function, refer to User's Guide [Copy Op-
erations].
If applying a password rule, the conditions that are required in the pass-
word are described below.
8 alphanumeric characters (only 8 alphanumeric character for the admin-
istrator password, and 8 alphanumeric characters or more for the user
authentication user password)
Only passwords with the same characters are not allowed.
Passwords that do not meet the password rule are not accepted. For the
password rules, refer to User's Guide [Copy Operations].
200/250/350
7 6 5 4 3 2 1 0
0 0 0 0 0 0 0 0 (HEX: 00)
Description
Specify whether to
use the Failed Access
Penalty function that
locks access when a
password (account
track and administra-
tor passwords) is en-
tered incorrectly three
times.
---------------------
For security, specify
whether to apply a
password rule.
---------------------
Setting
Description
0
Does not lock access
1
Locks access
00
* Do not change these bits.
0
Do not apply a password
rule
1
Apply a password rule
0000
* Do not change these bits.
9
Refer to
----------
----------
----------
----------
9-49