Specifying Settings For The Range Of Administrator Access Codes And The Information Indicated In The Report For Direct Faxing/Ip Relay Transmissions (Mode 368) - Konica Minolta bizhub 200 User Manual

7
Specifying settings for the range of administrator access codes and the
information indicated in the report for direct faxing/IP relay
transmissions (mode 368)
Specify the valid range of administrator access codes (administrator pass-
words). In addition, specify whether or not the results of direct faxing or IP
relay transmissions are indicated in the reception report.
Settings at time of purchase
Bits
Setting
Specifying the setting
During the production of this unit, the settings in the shaded cells were se-
lected.
Bit
7
6
5, 4, 3, 2
1
0
7-20
7 6 5 4 3 2 1 0
1 1 0 0 0 0 1 0 (HEX: C2)
Description
--------------------------
Specifies the valid
range for the adminis-
trator access code
(administrator pass-
word).
--------------------------
Specifies whether or
not the history is indi-
cated in the reception
report when scanning
and transmitting.
Specifies whether or
not the results of direct
faxing or IP relay trans-
missions are indicated
in the reception report.
Specifying management settings
Setting Description
1 *Do not change this bit.
0 A password must be en-
tered when logging on to
Administrator mode of Pa-
geScope Web Connection.
An administrator password
is not required when enter-
ing Administrator mode on
the machine.
1 A password must be en-
tered when logging on to
Administrator mode of Pa-
geScope Web Connection
and when entering Admin-
istrator mode on the ma-
chine.
1000 *Do not change these bit.
0 Not indicated
1 Indicated
0 Not indicated
1 Indicated
Page Refer-
ence
----------
----------
----------
----------
----------
200/250/350