Specifying Settings For The Range Of Administrator Access Codes And The Information Indicated In The Report For Direct Faxing/Ip Relay Transmissions (Mode 368) - Konica Minolta bizhub 350 User Manual

Specifying management settings
Specifying settings for the range of administrator access codes and the
information indicated in the report for direct faxing/IP relay
transmissions (mode 368)
Specify the valid range of administrator access codes (administrator pass-
words). In addition, specify whether or not the results of direct faxing or IP
relay transmissions are indicated in the reception report.
Settings at time of purchase
Bits
Setting
Specifying the setting
During the production of this unit, the settings in the shaded cells were se-
lected.
Bit
7
6
5, 4, 3, 2
1
0
200/250/350
7 6 5 4 3 2 1 0
1 1 0 0 0 0 1 0 (HEX: C2)
Description Setting
-------------------------- 1
Specifies the valid 0
range for the adminis-
trator access code
(administrator pass-
word).
1
-------------------------- 1000
Specifies whether or 0
not the history is indi-
1
cated in the reception
report when scanning
and transmitting.
Specifies whether or 0
not the results of direct
1
faxing or IP relay trans-
missions are indicated
in the reception report.
Description
*Do not change this bit.
A password must be en-
tered when logging on to
Administrator mode of Pa-
geScope Web Connection.
An administrator password
is not required when enter-
ing Administrator mode on
the machine.
A password must be en-
tered when logging on to
Administrator mode of Pa-
geScope Web Connection
and when entering Admin-
istrator mode on the ma-
chine.
*Do not change these bit.
Not indicated
Indicated
Not indicated
Indicated
7
Page Refer-
ence
----------
----------
----------
----------
----------
7-19