Specifying Whether Transmission Source Information Is Added When Directly Faxing, Performing An Ip Relay Operation, Or Forwarding Received Documents (Mode 352) - Konica Minolta bizhub FK-503 User Manual

Specifying whether transmission source information is added when di-
rectly faxing, performing an IP relay operation, or forwarding received
documents (mode 352)
Specify how transmission source information is added when directly faxing,
performing an IP relay operation, or forwarding received documents.
Settings at time of purchase
Bits
Setting
Specifying the setting
During the production of this unit, the settings in the shaded cells were se-
lected. The numbers on the right side indicate the page numbers with de-
scriptions for the corresponding function.
Bit
7
6
5
4
3, 2, 1, 0
bizhub 350/250
7 6 5 4 3 2 1 0
1 1 0 1 0 0 0 0 (HEX: D0)
Description Setting
----------------------- 1
Specifies where 0
transmission source
1
information is added
with direct faxing
and IP relay opera-
tions.
Specifies whether or 0
not transmission
1
source information
is added to received
documents that are
forwarded.
Specifies where 0
transmission source
1
information is added
when a received
document is for-
warded.
----------------------- 0000
Description
*Do not change this bit.
Outside of the document
Inside the document
Not added
Added
Outside of the document
Inside the document
*Do not change these
bits.
11
Page Refer-
ence
----------
----------
p. 11-50
----------
11-85