Charging The Stethoset Receiver's Rechargeable Battery - Sennheiser 506824 Instruction Manual

Putting the RS 5000 into operation
Battery LED
16 | RS 5000
Charging the stethoset receiver's rechargeable
battery
A complete charging cycle takes about 3 hours. Before using the
3 h
receiver for the first time, charge its rechargeable battery for a com-
plete charging cycle without interruption.
When the rechargeable battery is almost empty, the
100
%
LED lights up red and you hear 2 beeps in the stethoset receiver. The
Battery LED
receiver switches off after a few minutes.
Place the stethoset receiver into the transmitter's charging com-
partment so that the volume buttons face upwards. The ste-
thoset receiver is magnetically oriented to the correct position.
The stethoset receiver automatically switches off and the
tery
LED
display the charge status of the rechargeable battery. When the
rechargeable battery is fully charged, all LED segments light up
white.
–
st
1 LED segment flashes
LED segment lit 
st
1
nd
2 LED segment flashes
LED segments lit 
st nd
1 + 2
rd
3 LED segment flashes
All LED segments lit
LED flashes 
Battery
rapidly
on the transmitter lights up white. The stethoset
on the transmitter lights up white. The LED segments
Meaning
The transmitter is not charging.
The rechargeable battery is being
charged. Less than one-third of the
charge capacity is reached.
The rechargeable battery is being
charged. Up to one-third of the
charge capacity is reached.
The rechargeable battery is being
charged. Up to two-thirds of the
charge capacity is reached.
The rechargeable battery is fully
charged.
A charging error/battery error has
occurred (see page 28).
Receiver status
Bat-
3 h
100
%