Muratec MFX-2050 Field Engineering Manual page 374

5. Reattach the PCB NGP and the covers.
6. Plug the power cord and turn the machine on.
7. Initialize the memory module by pressing <Setting>, <*>, <1>, <6>, and [Yes].
Note: This setting ( [DRAM clear] ) will erase all of stored documents in the machine's memory.
8. Perform the memory test ( [DRAM clear] ) by the following procedure.
1) Press <Setting>, <*>, <1>, <1>, then select [DRAM Check] .
2) Use the numeric keys and one-touch keys [01] through [06] to enter Hex code (00 to FF), and
press <Start>.
Use the sharp key (#) to enter A, B, C, D, E and F. See table below.
A B
#, 0 #, 1
3) Enter RAM check area by number. (See table below)
Press
0 All DRAMs
1 The standard memory on the main control board
2 The first half of the 32MB Optional Memory PCB
3 The second half of the 32MB Optional Memory PCB
4) Press <Start>.
5) The machine shows the checked result. Press <Reset> to go back to the standby mode.
9. Print the "Fax Settings List" by pressing <Setting>, [List], [Setting List], [Fax Setting], and [Yes] to
see the memory amount becomes 40960 KB (40 MB).
10. Turn the machine off.
11. Reattach the covers and the harness.
C D E F
#, 2 #, 3 #, 4 #, 5
Check area
6-2